Contour Coffee Table Kickstarter Project: Week 2

Time for another Kickstarter update! It has now been two weeks since the launch of my Kickstarter campaign, meaning that it is just about halfway over. At this time the project is 70% funded, so the end is in sight! As I mentioned before, Kickstarter projects tend to lose momentum in the middle of the campaign, so the goal right now is to get more people visiting the page. If you haven't seen the project yet, take a look at my Kickstarter page to see all the rewards I'm offering. And, as always, please spread the word to anyone who might be interested!

Now, for anyone who's interested, here are a few pictures of different stages of the table's production.

The coffee table's four curves after being cut by a shopbot. Tabs are left in order to prevent the curves from moving during cutting

The coffee table's four curves after being cut by a shopbot. Tabs are left in order to prevent the curves from moving during cutting

The four curves - removed from the plywood sheet and holes drilled

The four curves - removed from the plywood sheet and holes drilled

After receiving a thin layer of polyurethane, the curves are placed in a jig and wiring commences.

After receiving a thin layer of polyurethane, the curves are placed in a jig and wiring commences.

When everything is wired up and excess cable is snipped, the completed base can be removed from the jig.

When everything is wired up and excess cable is snipped, the completed base can be removed from the jig.